Tag: cool roofing
TPO Roofing repair by M&M Construction Services LLC
This roof is a great example of why you should check your own work. This roof is less than 3 years old and has leaked since it was completed. Probing your own work will eliminate these small leaks.
Upon inspection and probing the welded seams we found at least 10 spots where the probe penetrated the seam, 2 of which were definitely a leak.
To address these leaks we cleaned the areas, welded the seams, and covered it with a fully welded TPO patch.
M&M Construction Services always probes all seams and patches before we consider the roof to be completed. For a contractor you can trust, don’t hesitate to call.
Thanks,
Michael
TPO roof surrounded with parapet walls
Here’s a complete replacement we finished recently. We Removed the existing EPDM and substrate down to the deck. Then we replaced any rotten wood and coca cola signs with new wood.
Finally we installed a new substrate, followed by a fully adhered TPO roof backed by GAF with a 20 year warranty.
For a contractor you can trust, give me a call. Michael 601.750.2274
Retro-fit TPO commercial roof
Here’s a TPO over metal PBR we completed. We use foam flute fillers to get a flat surface. Then a 1 inch ISO board was mechanically fastened over that filler. Finally a TPO membrane mechanically fastened and heat welded seams and boots. If you have a leaky low pitch roof, Give me a call….
Michael 601.750.2274
Thanks for looking!
Retrofit commercial roof
Here is a retro-fit metal roof for a commercial building in Jackson MS.
First, we remove vents, cover skylights with metal(for safety), and install roof huggers which fasten directly to underlying steel purlins.
Next we install blanket insulation to prevent any condensation problems with this low pitch roof.
Finally a die formed ridge cap is installed finishing off the roof.
And the final clean up!
Commercial Skylights
Recent hail damage to polycarbonate skylights. We replaced these with a thicker fiberglass light.
- 1
- 2