Here’s a TPO over metal PBR we completed. We use foam flute fillers to get a flat surface. Then a 1 inch ISO board was mechanically fastened over that filler. Finally a TPO membrane mechanically fastened and heat welded seams and boots. If you have a leaky low pitch roof, Give me a call…. Michael 601.750.2274 Thanks for looking!
Here is a retro-fit metal roof for a commercial building in Jackson MS. First, we remove vents, cover skylights with metal(for safety), and install roof huggers which fasten directly to underlying steel purlins. Next we install blanket insulation to prevent any condensation problems with this low pitch roof. Finally a die formed ridge cap is installed finishing off the roof.
Here’s a roof I inspected for a potential customer. Obvious hail damage was present but the workmanship was poor at best. Overlapping of roofing panels was backwards and screw placement was incorrect. So here’s a few things to consider to help ensure you don’t end up with a roof like this one. Is your contractor licenced with the Mississippi state